Claro INFINITY 401 Manuel d'installation rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Claro INFINITY 401. Claro INFINITY 401 7 pages.

Rear Panel and Hardware Connection

The following describes the proper steps for connecting your cable modem. Please be sure to follow the steps in the sequence outlined below.

Failure to do so could result in improper operation or failure of your cable modem.

Step 2

Connecting the

Ethernet Cord

Step 4

Connecting to

the AC Adapter

Step 1:

Step 3

Connecting the

Telephone cord

Step 2:

Step 3:

Step 1

Connecting the

Coaxial Cable

Step 4:

Connect a cable by feeding the F-connector on the back of the

cable modem. Ensure the center conductor of the 75 ohm coaxial

cable is inserted directly into the center of the F-connector. Secure

the coaxial cable by carefully threading the outer shell of the coaxial

cable connector onto the F-connector in a clockwise direction until

tight. Be careful not to over-tighten the connector or you may damage

either the connector or the cable modem.

Connect the cable modem to an IEEE 802.3 10Base-T / 802.3u 100

Base-TX / 802.3ab 1000Base-T Network using a RJ-45 male-terminated

Ethernet cable. This cable modem equips with four Ethernet ports, you

can connect two PCs to the cable modem at the same time if necessary.

Connect the telephone sets to TEL1 and TEL2. Use RJ-11 telephone

line to connect TEL1/TEL2 port on the cable modem and telephone

socket on telephone.

Connect the AC Adapter to the cable modem by inserting the barrel-

shaped connector into the mating power connector on the back of the

cable modem. Exercise carefully to ensure the connectors are properly

aligned prior to insertion and ensure the two connectors engage

completely. The cable modem is shipped with an AC adapter. Remember

to use only power adapter that came with the cable modem. Other power

adapters might have voltages that are not correct for your particular cable

modem. Using a power adapter with the wrong voltage can damage the

cable modem.