DirekTronik SX-SWE01B Manuel d'utilisation - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} DirekTronik SX-SWE01B. DirekTronik SX-SWE01B 20 pages. Mixed input type-c vga hdmi, hdmi 2.0 hdbaset switch, support 4k@60hz yuv4:4:4, 18gbps, hdr

Imprimer la page
Instructions:
1). All commands start from "#", "%d" parameters No.
2). The "_" in the commands cannot omit.
The following table is only an example. Please refer to the list of instructions.
Instruction
description
Command Query
Video Input Channel Switch
Audio embedded in
Audio IIS out VOL Set
EDID Mode Set
Factory Reset
Baudrate Set
IP Query
DHCP Set
Please refer to above "Command list" for details.
For example:
Operation format
Video Input Channel Switch: #video_d in1 (Switch to Type C input)
Audio embedded in: #audio_d enc=1 value=7 (MIC VOL adjust to 7)
Audio IIS out VOL Set: #audio_d iis=7 (Analog audio VOL adjust to 7)
EDID Mode Set: #edid_d mode=2 (Copy EDID of HDMI out for input)
Baudrate Set: #uart baud=0 (Current baudrate set is 9600)
DHCP Set: #ip dhcp=1 (DHCP open)

11. Power Off and Reboot Input Priority Mode

When HDBaseT switch reboot and it inspect the current input signal in "None" status,device will auto switch to
higher priority input signal(If there is no higher priority input than current one,it will switch lower priority input).
Priority table for input:
Signal for Input
HDMI 1
HDMI 2
Type C in
VGA in
Command format，
(%d: parameter number)
#cmd
#video_d in%d
#audio_d enc=%d value=%d
#audio_d iis=%d
#edid_d mode=%d
#factory
#uart baud=%d
#ip help?
#ip dhcp=%d
Priority
The highest
Second
Third
Fourth(the lowest)
parameter 1
1:TYPEC
2:VGA
3:HDMI1
4:HDMI2
0:HDMI
1:IIS,MIC
2:Mute
VOL adjust numerical
range(0~10)
0:(4K60),1:(1080p)
2:(HDMI),3:(HDBT)
0:Close ,1:Open
Reboot and inspect HDMI1,if none signal,device switch
to next lower priority input
Reboot and inspect HDMI 2,if none signal,device auto
switch to higher priority input,if not,it switch to next
lower priority input of signal
Reboot and inspect Type C,if none signal,device auto
switch to higher priority input,if not,it switch to next
lower priority input of signal(VGA)
Reboot and inspect VGA,if none signal,device auto
switch to higher priority input,if not,it will keep current
input of signal(VGA)
16
Operating Instruction
parameter 2
MIC VOL adjust numerical
range(0~10)
0:9600
1:19200
2:38400
3:57600
4:115200
Switch Condition