CLAS HU 1121 Manuel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} CLAS HU 1121. CLAS HU 1121 13 pages. Electric brake bleeder

HU 1121

ELECTRIC BRAKE BLEEDER

DESCRIPTION

Brake fl uid is taken from its container by a pump operating at up ta 3.0 bar pressure and is

continuously pumped into the brake fl uid reservoir. The individual wheel brake cylinders can then

be drained of their used brake fl uid until the new brake fl uid cornes through.

You thus avoid the regular emptying and fi lling operations, in contrast ta conventional systems

and also avoid any resulting water absorption in the brake fl uid.

The pump used ta fi ll the brake fl uid reservoir is equipped with pressure monitoring. Should it

not be possible ta build pressure or should the pump pull in air, the pump switches itself off

automatically.

Operating/device schematic:

1- ON / OFF Switch;

2- Start Button;

3- Fuse;

4- Pressure Regulator;

5- Pressure Gauge;

6- fi ller hase;

7- Suction Switch;

8- Suction Hase;

9- Power Gord;

The adapter (Diff erent versions are

available.), used ta connect to the

brake fl uid reservoir, is not shown.

TECHNICAL DATA

Voltage: 220-240V 50/60Hz;

Max. Power: 35W;

Working Pressure: 0.6 - 3.0 bar;

Filling Hase Length: 3.5m;

Dimension in mm: 285x230x370mm;

Max. Flow Rate: 1.2L/M;

Container Empty Protection: Yes;

Noise: 70dB;

DEPLOYMENT / WORKPLACE

The brake maintenance device should be installed on a fi at surface. Make sure that the fi lling hase

is not under any mechanical tension, for example when the vehicle is raised on a hydraulic lift.

With the startup procedure and operation, the area around the brake maintenance device becomes

its workplace. Otherwise, there is no fi xed workplace for the brake maintenance device.