Lenovo ThinkCentre Tiny-in-One 24 Manuel de l'utilisateur - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Lenovo ThinkCentre Tiny-in-One 24. Lenovo ThinkCentre Tiny-in-One 24 40 pages.

Imprimer la page

Adjusting your monitor image

This section describes the user control features used to adjust your monitor image.

Using the user controls

Your monitor has four user controls on the front panel. To locate the user controls, see "Locating connectors and

controls on your monitor" on page

On Screen Display (OSD) main menu.

Mode-switching button / back button

•

Used to switch between the AIO mode (using the Tiny installed) and the DP mode (using an external desktop

computer). You also can press the button to move back and exit from the OSD menu.

•

Left shift button

Used to move to the left on the OSD menu.

•

Right shift button / brightness control

Used to move to the right on the OSD menu and adjust the brightness.

Selection button / menu-opening button

•

Used to open the OSD main menu and select an option.

Using the OSD controls

The settings adjustable with the user controls are viewed through the OSD, as shown below.

Note: When switching to AIO mode, the monitor and the Tiny share the same power button on the monitor,

However, if the enhanced power saving mode is enabled in the BIOS of the Tiny, you can only use the

power button of the computer to turn on the computer.

ThinkCentre Tiny-in-One 24 User Guide

. You can use the user controls to adjust some settings of your monitor on the

To use the controls:

1.Press

to open the main OSD menu.

2.Use

to move among the icons. Select an icon and press

function. If there is a sub-menu, you can move between options using

then press

to select that function. Use

to save.

3.Press

to move backwards through the sub-menus and exit from the OSD.

4.Press and hold

for 10 seconds to lock the OSD. This will prevent accidental

adjustments to the OSD. Press and hold

adjustments to the OSD.

5.Enables DDC/CI by default. Use OSD Left Arrow Key, press and hold the buttons

seconds to disable/enable DDC/CI function. The words " DDC/CI

Disable/DDC/CI/Enable" shows on the screen.

to make adjustments. Press

for 10 seconds to unlock the OSD and allow

to access that

for 5