CLAS OP 1407 Manuel - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} CLAS OP 1407. CLAS OP 1407 12 pages. Pneumatic equipement impact wrenches/ratchet wrenches
Également pour CLAS OP 1407 : Manuel (12 pages)
Imprimer la pageOP 1407
TOOLING APPLICATION
Impact wrench
Ratchet
Drill
Screwdriver
Sanders
Polisher
Air saw
File
Air hammer
Needle scaler
Windscreen cutter
Nibbler
Shear
Die grinder stell
Angle grinder
Blind riveting
Belt sander
Engraving pen
Cut off tools
Spot weld drill
Sticker grinder
AIR SUPPLY REQUIREMENTS
• Supply the tool with 6.3bar of clean, lubricated, dry air. Higher pressure drastically reduces tool life and/or can
cause sever injury.
• Connect the tool to the airline using pipe, hose and tting sizes.
• Do not install a quick coupler directly into the air hose connector.
• In order to have the tool working to full satisfaction, the minimum air supply must beat least 10% higher than the
indicated air consumption of the air tool.
• Use recommended hose size and length. Don not connect the tool to the airline system without incorporating an
easy to reach and operate air shut off valve.
• Air supply should be lubricated.
1" IMPACT WRENCH 2441Nm
For tightening and unscrewing of threaded fastener
Tightening and unscrewing of various kinds of bolts and nuts
For drilling holes in metals, wood and plastics
For tightening and unscrewind of wood ant metal screws with hex and Phillips
head
To remove layers of paint and lling material
To polish painted surfaces and nish surfaces prior to painting
For cutting sheet steel, carbody panels, pipes, steel, plastic and wood
File for metals, wood and plastics
To cut car body panels, bolts, screws and nuts
To remove rust, paint and cinder after welding
To remove cement, sealing material and rubber from windscreen frame
To cut (nibble) car body panels, sheet steel, stainless steel and corrugated
panel sheets
With this tool you can cut metal plate
For use with bonded abrassive mounted grinding wheels rotary les and car-
bide burrs providing their speed rating matches the speed of the grinder
Light grinding and dressing of welds
To rivet two metal panels together
For sanding and polishing in con ned areas
To mark tools and parts made out of metal, stone and other hard materials
Used for cutting operation on bearings, exhaust pipes and clamps
For controlled removal of spot welds on car body repairs
For removing sticker, labels and tags from painted at surfaces