CTS IES-3006SFP-F1-DR Manuel - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} CTS IES-3006SFP-F1-DR. CTS IES-3006SFP-F1-DR 16 pages. Industrial ethernet switch

Imprimer la page

2. INSTALLATION

To properly install the Industrial Ethernet Switch, please follow the procedures listed

below. Procedures covered in this chapter are described below in separate sections.

 Installation Requirements

 Unpacking the Industrial Ethernet Switch

 Installing the Industrial Ethernet Switch

 Powering on the Industrial Ethernet Switch

 Connecting the Industrial Ethernet Switch to the Network

2.1 Installation Requirements

ATTENTION

Be sure to power off before installing or wiring your Industrial

Ethernet Switch.

Be sure to calculate the maximum possible current in each power

wire and common wire. If the current goes above the maximum

ratings, the wiring could overheat, causing serious damage to your

equipment.

Be sure to read and follow below important guidelines :

 Do not run signal or communications wiring and power wiring through the

same wire conduit. Wires with different signal characteristics should be

routed separately to avoid interference.

 It is recommended that wiring which shares similar electrical characteristics

can be bundled together.

 Keep input wiring and output wiring separate and label the wiring to all

devices in the system if necessary.

2.2 Checking the Package Contents

Unpack the package carefully and check the package contents. The package should

contain the following items:

 Items included in standard package:

 1 Industrial Ethernet Switch

 1 Documentation CD