CTS PATCO PE-BT-03 Mode d'emploi - Page 3

Parcourez en ligne ou téléchargez le pdf Mode d'emploi pour {nom_de_la_catégorie} CTS PATCO PE-BT-03. CTS PATCO PE-BT-03 5 pages. Land warrior battery tester / analyzer

Imprimer la page

Operation

Testing Sequence 1

Operational Functionality

1. Connect battery to tester with docking station or cable, see the

section Connecting to Batteries.

2. Press ON button until startup screen displays PATCO

3. Press and release TEST button. During the test cycle, Testing

will be displayed

(figure

capability and SMBus communication capability. After

approximately 12 seconds, testing will be complete and the

screen will display either PASS SOC

on the top LCD line and illuminate the green pass LED indicator

or red fail LED indicator.

4. The tester will return to IDLE and turn off after 30 seconds if

not used.

Note:

During the charge portion of the test, if the 9V battery to the

tester drops below 5 volts, the test will exit without completing and

the Replace 9V Battery LED indicator will illuminate.

PASS Indication

The top line displays PASS, and the second line displays the state of

charge

(figure

3).

Fail Indication

The top line displays FAIL

(figure

fail code. See Table 1, Fail Codes.

Fail Codes

The second line of the LCD will display the fail code for the battery

under test, see Table 1, Fail Codes.

Fail Codes from 2

CHARGE

DISCHG

COMM

CCAP

BV LOW

The information contained herein is for reference only and does not constitute a warranty of performance

CTS IS AN AUTHORIZED RESELLER AND DISTRIBUTOR FOR PATCO ELECTRONICS

2) for the charge capability, discharge

(figure

3) or FAIL

4), and the second line displays the

line

Battery failed to accept charge

Battery failed to discharge

Battery failed to communicate over SMBus

Battery has a low full charge capacity < 80%

Battery is deeply discharged < 2.13V per cell

Fail Codes displayed on second line of display (figure 4)

Creating Technology Solutions, LLC

Tel 321-418-3055

Fax 321-418-3044

All information subject to change without notice

O P E R A T I N G I N S T R U C T I O N S

(figure

1).

(figure

Condition

Table 1

P.O. Box 5827

Titusville, FL 32783

| www.crtes.com |

CAGE Code: 6Y7W5

L AN D W A R R I O R B AT T E R Y

T E S T E R / A N AL Y Z E R

P E - B T - 0 3

PATCO

FW x.x

Figure 1

Startup screen display

where x.x is the firmware

version

Testing

xxxx

Figure 2

Screen display during test

PASS

SOC=xx%

Figure 3

Screen display when

battery passes test, where

xx is the percent state of

charge

FAIL

xxxx

Figure 4

Screen display when

battery fails test, where

xxxx is the failure code

| April 2014

Rev.02