Dirt Devil Centrino Cleancontrol Manuel d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dirt Devil Centrino Cleancontrol. Dirt Devil Centrino Cleancontrol 13 pages. Centrino cleancontrol bagless cylinder vacuum cleaner

Imprimer la page

Maintenance

3.4 Cleaning / changing the motor

protection filter

1. Switch off the appliance, remove the dust

container and empty it Chapter 3.1,

"Emptying the dust container".

2. Remove the motor protection filter from its

holder (Fig. 13).

3. Tap the remaining dust into a dustbin.

4. Rinse the motor protection filter with cold

water until the runoff from the filter is clear

(Fig. 14). However, replace a heavily soiled

or damaged motor protection filter with a

new one.(Chapter 5.1, "List of consuma-

ble parts")

5. Leave the motor protection filter to dry at

room temperature for at least 15 hours

(Fig. 15).

6. Do not put the filter back into its holder be-

fore it is completely dry.

Centrino

cleancontrol

3.5 Cleaning / changing the central

laminar filter

1. Switch off the appliance, remove the dust

container and empty it Chapter 3.1,

"Emptying the dust container".

2. Remove the lid of the dust container by

turning it counter-clockwise (Fig. 16/1.,2.).

3. Then twist the central laminar filter off the

cover by turning it counter-clockwise

(Fig. 17/1.,2.).

4. Hold the central laminar filter over a dustbin

and only then separate the filter elements

from each other.

5. For a rough cleaning, tap the dirt from both

parts by lightly tapping on all sides.

6. To thoroughly clean the central laminar fil-

ter without water, use the supplied furniture

brush as shown (Fig. 18).

NOTE:

If the elements of the central laminar filter

are still dirty after a thorough dry cleaning,

thoroughly rinse them with a shower-head.

Do not use detergents or brushes with hard

bristles for this task. Then leave the filter ele-

ments to dry (approx. 15 hrs at room temper-

ature). Only reassemble them when they are

completely dry.

7. Push the elements of the central laminar fil-

ter together again.

8. If your central laminar filter is equipped with

the optional sheath, take care that the up-

per edges of sheath and filter are exactly

flush when fitted (Fig. 19)..

9. Refit the central laminar filter to the dust

cover of the dust container by tightening it

clockwise (Fig. 20).

10. Put the cover back on the dust container

and lock by turning it clockwise. Take care

that the release catches for dust cover and

bottom plate correspond when fitting them

(Fig. 21).

11. Replace the dust container It must catch

with a click.