Cub Cadet 188 Manuel de l'opérateur - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Cub Cadet 188. Cub Cadet 188 16 pages. 19-inch 3-n-1 rechargeable lawn mower
Également pour Cub Cadet 188 : Manuel de l'opérateur (18 pages)

Imprimer la page

Maintaining

Your Lawn

Mower

WARNING

Always stop the

motor, and remove

key before cleaning,

lubricating or per-

forming any repairs

or maintenance on

the lawn mower.

To reduce the risk of

electric shock, do not

expose the mower to

water.

Never operate mower

unless the trail shield

is in place and work-

ing. Never operate

mower with damaged

safety devices.

Failure to do so, can

result in personal

injury.

Due to a potential

shock hazard, DO

NOT attempt to

remove the motor/

battery shroud. There

are no user service-

able parts inside.

Contact your nearest

Authorized Service

Center if repairs are

needed.

Figure 5-1: Areas to lubricate on the mower.

Figure 5-2: Remove the trail shield.

General Recommendations

• Always observe safety rules when performing

any type of maintenance.

• The warranty on this lawn mower does not cover

items that have been subjected to operator abuse

or negligence. To receive full value from warranty,

operator must maintain the lawn mower as

instructed here.

• All adjustments should be checked at least once

each season.

• Periodically check all fasteners and make sure these

are tight.

Lubrication

• Lubricate the wheels at least once a season with

• Lubricate the torsion spring and pivot point on the rear

Deck Care

The underside of mower deck should be cleaned after

each use as grass clippings, leaves, dirt and other debris

will accumulate. This accumulation of grass clippings,

etc., is undesirable as it will promote rust and corrosion.

1. Remove any buildup of grass and leaves on or around

2. If debris is allowed to build up on the underside of the

Replacing Trail Shield

result in personal injury.

The trail shield is subject to wear and damage which

could expose moving parts or allow objects to be

thrown. For safety protection, frequently check the trail

shield and replace immediately with original equipment

manufacturer's (OEM) part only, listed in this manual.

1. To remove trail shield, lift rear door, and press shield

2. Remove shield from opposite hole and replace with

WARNING: Always stop the motor and

remove key before cleaning, lubricating

or performing any repairs or mainte-

nance on the lawn mower.

light oil (or motor oil). If wheels are removed for any

reason, lubricate surface of the pivot arm and inner

surface of the wheel with light oil. See Figure 5-1.

discharge door and side mulch plug periodically with

light oil to prevent rust. See Figure 5-1.

WARNING: To reduce the risk of electric

shock, do not expose the mower to

water.

the motor cover (do not use water). Wipe the mower

clean with a dry cloth occasionally.

unit, tilt the mower and scrape it clean with a suitable

tool (make certain the key is removed).

WARNING: Never operate mower unless

the trail shield is in place and working.

Never operate mower with damaged

safety devices. Failure to do so, can

in on either side to remove from hole. See Figure 5-2.

new shield in the opposite order and manner of

removal.