Attach the flexible hose to the
ATTACH HOSE: Attach the
cleaner. Match the slots on the
flexible hose to the cleaner
hose to the tabs on the hose
(Diagram 2). Match the arrows
inlet (la). Push down firmly on
on the hose to the tabs on the
the cuff and turn clockwise.
clear hose inlet (Diagram 2a).
Push down firmly on the
cuff
and turn dockwise.
HOW TO OPERATE
lnserl the wand into the side of
the cleaner. Press down firmly
to secure.
(A) Slide 2-in-1 tool onto tool
dip on the back panel with bris-
tles facing out. (B) Slide the tel-
escopic wand, small end down,
into
t h e
round slot behind han-
dle. (C) Slip crevice tool into
square slot behind handle.
Plug cord into electrical outlet.
To release handle, push pedal
Move the handle and adjust it
Turn deaner "on" by pressing
down with foot. Use cord guide
to the desired position for (A)
power pedal located on the
to store cord out of way while
storing the upright, (8) operat-
left back side of unit.
vacuuming.
ing the cleaner,
and (C)
depress the handle release
pedal again to clean under fur-
niture.
ABOVE FLOOR CLEANING
CAUTION: Brush agitator continues to rotate while hose is removed or in use at all times while cleaner
)m brush area while cleaner is on.
Handle should be in the
upright poslon before adjust-
ing the carpet setting. Turn
height adjustment knob to
match the surface being
cleaned. Once height is seled-
ed the nozzle will go to the cor-
rect position. NOTE: Rotating
brush could cause area rug
fringe to become tangled with-
in cleaner. Use caution when
vacuuming throw rugs with
fringe.
Pull and turn the carpet hose
Cleaner must be in the upright
selector counterclokwise (5)
position to
lift
the rotating
to use the hose and clockwise
brush off the carpet when
to dean carpets (5a). Pull and
cleaning above the floor. Put
turn the seledor to the desired
d e m in its upright p o s h .
p o s h BEFORE proceeding
Remove hose from
the
side of
to dean.
the
deaner
using the handle.