Dirt Devil collector of garbage Manuel du propriétaire - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dirt Devil collector of garbage. Dirt Devil collector of garbage 8 pages.

Imprimer la page

HOW TO ASSEMBLE

UNPACKING: This product requires assembly.

Carefully remove the product and any accessories from the box. Make sure that all

items listed in the packing list are included.

WARNING:

Do not use this product if any parts on the Packing List are already assembled to your

product when you unpack it. Parts on this list are not assembled to the product by the

manufacturer and require customer installation. Use of a product that may have been

improperly assembled could result in serious personal injury.

• Inspect the product carefully to make sure no breakage or damage occurred dur-

ing shipping.

• Do not discard the packing material until you have carefully inspected and satis-

factorily operated the product.

• If any parts are damaged or missing, please call 1-800-321-1134 for assistance.

BLOWER MODE:

Put blower attachment (A1) on blower tube (A2) so

arrows are on same side.

Align the grooves on the blower tube (A) Fig.3 with the

grooves on the blower outlet (B). Push the blower

tube onto the blower outlet until it clicks into posi-

tion.

Warning! The blower inlet and outlet both have a

built-in limit switch which

prevents the blower from starting if the blower

tube (A) and the blower inlet safety guard (C) are

not installed or not installed properly. Make sure

the blower tube and blower inlet safety guard are

installed before attempting to use the blower.

To install the blower inlet safety guard (A) Fig.4 to

the blower inlet, position the blower inlet safety

guard over the blower inlet, rotate the safety guard

approximately 90 degrees. Make sure the safety

guard has engaged the blower inlet grooves, at

this point you must not be able to lift the safety

guard upwards. Make sure the limit switch actua-

tor (B) engages the inner limit switch, then lock the

blower inlet safety guard using the locking clip (C).

The blower is now ready to use, make sure you

have read and understood the safety and operation

instructions before using.

It is recommended to install the adjustable shoulder

strap (D) Fig.3 to the blower handle (E).

WARNING:

If any parts are damaged or missing do not operate this product until the parts are replaced.

Use of this product with damaged or missing parts could result in serious personal injury.

A 1

Figure 3

Figure 4

Figure 5

SYMBOLS

Some of the following symbols may be used on this product. Please study them and learn their

meaning. Proper interpretation of these symbols will allow you to operate the product much better.

SYMBOL

NAME

Safety Alert

Read Operator's Manual

Eye and Hearing Protection

Wet Conditions Alert

Keep Bystanders Away

Long Hair

Loose Clothing

Volts

Amperes

Hertz

Watt

min

Minutes

Alternating Current

Direct Current

Class II Construction

DESIGNATION/EXPLANATION

Indicates a potential personal injury hazard.

To reduce the risk of injury, user must read and

understand operator's manual before using this

product.

Always wear eye protection with side shields

marked to comply with ANSI Z87.1 along with

hearing protection.

Do not expose to rain or use in damp locations.

Keep all bystanders at least 50ft. away.

Failure to keep long hair away from the air inlet

could result in personal injury.

Failure to keep loose clothing from being drawn

into air intake could result in personal injury.

Voltage

Current

Frequency (cycles per sound)

Power

Time

Type of current

Type or a characteristic of current

Double-insulated construction