Dirty hand 100481 Manuel d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dirty hand 100481. Dirty hand 100481 16 pages. 5-ton electric log splitter

Imprimer la page

Operation

PREPARATION OF THE LOG

Both ends of the log should be cut as square as possible to prevent

the log from rotating out of the splitter during operation.

Do not split logs greater than 20 in. in length.

WORK AREA

• Do not operate the log splitter on icy, wet, muddy or otherwise

slippery ground. ONLY operate your log splitter on level ground.

Operating on a slope could cause the log splitter to roll over or

logs to fall off of the equipment, which could result in injury.

• Do not operate your log splitter in a damp or rainy environment

to avoid electric shock or short circuits.

• Use a tire chock or block on the wheels to prevent movement of

the log splitter while in operation.

• Operate the log splitter in daylight or under good artificial light.

• Keep the work area free of clutter. Remove split wood from

around the log splitter immediately after each use to avoid

potential tripping.

OPERATION OF THE LOG SPLITTER

• Make sure the power switch is in the OFF position before

plugging in the cord to avoid unintentional starting.

• Ensure the motor is properly grounded or apply protection device.

Only use rubber-jacketed cable of sufficient lead cross section as

an extension cable.

• Split wood in the direction of the grain only.

• Hold the sides of the log when loading it on the splitter.

• Make sure the operator knows how to stop and disengage the

controls before operating.

• Do not place hands or feet between the log and splitting wedge

during forward or reverse stroke. Serious injury or death could

result.

• Keep hands away from the ram, wedge and partly split logs.

DANGER