Dirty Hand Tools 106779 Manuel d'utilisation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dirty Hand Tools 106779. Dirty Hand Tools 106779 12 pages. 21 inch

Imprimer la page

PROBLEM

Recoil will not pull out or is difficult to pull.

(Refer to the engine Owner's Manual)

The engine will not start.

Engine smokes.

Troubleshooting

BEFORE PERFORMING ANY MAINTENANCE

PROCEDURE STOP THE ENGINE, WAIT FIVE (5)

MINUTES TO ALLOW ALL PARTS TO COOL.

Disconnect the spark plug wire,

keeping it away from the spark plug.

• Check the engine oil level.

• There may be an oil compression lock in the cylinder. Take

out the spark plug; hold a rag over the spark plug hole and

pull the recoil cord several times to blow out any oil in the

cylinder. Wipe off the spark plug and reinstall it.

• The recoil may be broken or jammed.

• Check for proper attachment of the spark plug wire.

• Check that the engine has the right amount of clean oil. If

the oil is dirty, change it following the procedure on page 10.

• Use only fresh, clean, unleaded gas. If the gas is old, change

it. Use a fuel stabilizer to keep gas longer than one month.

• Check that the air filter is clean.

• Make sure that the spark plug is clean. If the spark plug is

dirty or cracked, change it. If it is oily, leave it out, hold a

rag over the spark plug hole and pull the recoil cord several

times to blow out any oil in the cylinder, then wipe off the

spark plug and reinsert it.

• Check the oil level and adjust as needed.

• You may be operating the machine on too great an incline.

• Check the air filter and clean or replace if needed.

• You may be using the wrong oil - too light for the

temperature. Refer to your engine Owner's Manual for

detailed information.

Visit our web site at www.dirtyhandtools.com or call

1-877-487-8275 for assistance.

WARNING

SOLUTION