Dirty Hand Tools 101100 Manuel d'utilisation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dirty Hand Tools 101100. Dirty Hand Tools 101100 20 pages. 2” diameter semi-trash pump 7hp/208cc engine

Imprimer la page

Hose Connection

USE ONLY A NON-COLLAPSIBLE INTAKE HOSE
DO NOT OVER TIGHTEN HOSE CLAMPS
The suction hose must be reinforced or be constructed of
non-collapsible material. Do not use a hose with an inside
diameter smaller than the pump's intake and discharge ports.
1. Slide a hose coupling ring over the hose coupler, then place
a gasket on the end of the hose coupler.
2. Thread the hose coupling ring onto the intake port, and
turn clockwise until fastened securely.
3. Slide a hose clamp over the end of the suction hose. Slide
the hose onto the hose coupler. Use a screwdriver to
tighten the hose clamp until secure.
4. Slide a hose clamp over the other end of the suction hose.
Slide the intake strainer into the end of the suction hose.
Use a screwdriver to tighten the hose clamp until secure.
INTAKE
STRAINER
5. For the discharge hose, slide a hose coupling ring over the
hose coupler and place a gasket on the end of the hose
coupler.
6. Thread the hose coupling ring clockwise onto the discharge
port until tightened securely.
7. Slide a hose clamp over the end of the discharge hose.
Slide the discharge hose onto the hose coupler. Use a
screwdriver to tighten the hose clamp until secure.
10
!
CAUTION
DISCHARGE
HOSE
HOSE
CLAMP
SUCTION
COUPLER
HOSE
COUPLING
HOSE
RING
HOSE
GASKET
INTAKE
PORT
DISCHARGE
PORT