Dirty Hand Tools 101100 Manuel d'utilisation - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dirty Hand Tools 101100. Dirty Hand Tools 101100 20 pages. 2” diameter semi-trash pump 7hp/208cc engine

Imprimer la page
Disconnect the spark plug wire, keeping it away from the spark plug.
PROBLEM
The engine will not start.
• No fuel in tank or fuel valve closed.
• Choke not in start position.
• Low quality or deteriorated, old gasoline.
• Dirty fuel passageways blocking fuel flow.
• Carburetor needle stuck. Smell of fuel in air.
• Too much fuel in chamber.
• Spark plug wire not connected securely.
• Spark plug electrode wet or dirty.
• Incorrect spark plug gap.
• Spark plug wire or spark plug broken.
• Cylinder not lubricated after long storage.
• Clogged fuel filter.
Engine misfires, backfires or knocks.
• Spark plug wire loose.
• Incorrect spark plug gap.
• Spark plug wire or spark plug broken.
• Low quality or deteriorated, old gasoline.
• Engine too cold.
• Engine knocks.
Engine stops suddenly.
• Low quality or deteriorated, old gasoline.
• Defective fuel cap creates vacuum.
• Improper idle speed.
• Incorrect timing, deposit buildup, worn
engine or other mechanical problem.
Engine Troubleshooting
BEFORE PERFORMING ANY MAINTENANCE
PROCEDURE STOP THE ENGINE, WAIT FIVE (5)
MINUTES TO ALLOW ALL PARTS TO COOL.
!
WARNING
SOLUTION
• Add fuel and open fuel valve.
• Place choke in START position and pull recoil starter.
• Drain fuel. Add fresh 87+ octane unleaded gasoline.
• Clean out fuel passageways using fuel additive.
• Gently tap side of carburetor with screwdriver handle.
• Turn choke to RUN position.
• Connect spark plug wire securely to spark plug.
• Remove and clean spark plug. Reinstall spark plug and restart.
• Reset spark plug gap according to specifications.
• Replace spark plug and/or spark plug wire.
• Remove spark plug. Pour tablespoon of oil into spark plug hole.
Replace spark plug. Crank engine a few times and try to start.
• Replace fuel filter.
• If the engine still will not start, visit our web site at www.
dirtyhandtools.com or call 1-877-487-8275 for assistance.
• Tighten spark plug wire.
• Reset spark plug gap according to specifications.
• Replace spark plug and/or spark plug wire.
• Drain fuel. Add new fresh 87+ octane unleaded gasoline.
• Use cold weather fuel and oil additives.
• Engine overloaded, do not exceed recommended load rating.
• Drain fuel. Add fresh 87+ octane unleaded gasoline.
• Test and replace fuel cap.
• Move choke to RUN position.
• Requires qualified technician.
17