ABBA STA02 Manuel d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} ABBA STA02. ABBA STA02 4 pages. 12v lanscape light specialist
Imprimer la pagefixture(s) must be installed in accordance with all local codes and ordinances.
Do not instal within 10 feet of a pool, spa or fountain
To ensure optimal performance and safety, it is
important to use our fixtures ONLY with a low
voltage landscape transformer. This transformer
reduces the voltage from 120V to 12V, making it
safe and suitable for outdoor use.
When installing the fixture(s), please follow
these instructions carefully:
1.Before
installation,
the power is turned off for your safety.
2.Hold the FIXTURE against the wall at the
desired height and orientation. Ensure it is level
and aligned according to your preferences.
3. Using a pencil or marker, carefully mark the
hole location on the wall.
4. Select an appropriately sized for the hole,
which should match the diameter of the
FIXTURE.
5. Position the drill on the marked spot and
gently drill hole into the wall at the marked
location.
6.For concrete installation, To begin, construct
conduit raceways inside the concrete formwork
by using one-inch dowels and PVC pipe before
pouring the concrete. After the concrete has
cured, remove the dowels and proceed to finish
the outer surface of each riser if you are
installing it in stairs.
7.Confirm that the FIXTURE is firmly and evenly
attached to the wall, without any wobbling or
misalignment. Use a level to verify that the
fixturel is vertically aligned, as desired.
CAUTION:
INSTALLATION INSTRUCTION
please
ensure
that
www.ABBALightingUSA.com
We recommend using WN12 waterproof wire nuts
(sold separately) for optimal connectivity.
8.Strip the insulation: Carefully strip approximately
3/4 inch (1.9 cm) of insulation from the ends of the
two wires you wish to connect. Ensure that the bare
metal ends are clean and free from any frayed
strands.
9. Align the wires: Hold the stripped ends of the two
wires together, aligning them neatly and ensuring
that no stray strands are crossing over.
10. Insert the aligned ends of the wires into the wire
nut, ensuring that they go all the way in. The bare
ends should be completely covered by the wire nut.
Twist the wire nut: Firmly twist the wire nut
clockwise onto the wires, ensuring a secure
connection. Continue twisting until the wire nut is
tight and snug. Test the connection: Gently tug on
each wire to ensure they are securely held by the
wire nut. For added safety, it is recommended to
apply electrical tape around the wire nuts and wires
as an extra layer of protection.
11. Place the FIXTURE against the wall, aligning the
hole you created.
12. Remember to test the fixture after making any
adjustments to ensure it is functioning correctly
and that the lighting is set to your preferences.
13. Once the fixture(s) have been installed
securely, it's time to turn on the power and enjoy
the enhanced lighting experience! Locate the
power switch or breaker that controls the fixture(s)
and turn it on. Take a moment to observe the
lighting effect
Remember to regularly maintain and clean the
fixture(s) to ensure optimal performance and
longevity. Refer to the manufacturer's instructions
for specific details on how to care for your
particular fixture.