Disc Makers ReflexPro7 Manuel de démarrage rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Disc Makers ReflexPro7. Disc Makers ReflexPro7 2 pages. Cd-r disc duplicator reflexpro series
Également pour Disc Makers ReflexPro7 : Manuel d'instruction (13 pages), Manuel de l'utilisateur (15 pages)

Imprimer la page

IRECT

ISC TO

ISC

The Disc-to-Disc mode will duplicate the CD

master that is placed in the ReflexPro's top

drive – also called the source (Src) drive – to

blank CD-Rs that are loaded into the unit's

remaining drives. The ReflexPro has been pre-

set to duplicate in the Hard Drive-to-Disc mode,

but can easily be set to the Disc-to-Disc mode.

1. Power on the ReflexPro by pressing the round

button at the bottom right on the front of the

unit. The system will initialize and perform a

self test, which will be displayed on the LCD

display area.

2. When the self test is complete, the 1. Copy

display will appear on the LCD screen. Press the

DOWN arrow until 8. Select Source appears on

the display screen.

Press the ENT button and the following

image will appear on the display screen:

SRC: HDD

00 IDE0 Master

4. Press the DOWN arrow once. Src: CD-RW 01

IDE1 master will be displayed on the screen.

Press the ENT button and the LCD will display

CD-RW selected. Press ENT again.

5. Press the UP arrow to return to 1. Copy. You

will notice that P: A is no longer displayed on

this screen. P: A is only displayed when copying

in the Hard Drive-to-Disc mode (see opposite

side of this guide).

6. To start the duplication process, load the top

drive with your CD master. Load the remaining

OPY

drives with the number of CD-Rs you wish to

duplicate. You can duplicate from one CD-R to

as many CD-Rs as the unit can accommodate.

For the best results, always use high-quality

CD-R media.

7. Press the ENT button to begin duplicating.

The unit will automatically analyze the master

disc (this may take a few seconds), and begin

duplicating at the maximum recording speed.

8. The LCD will display the copying progress.

The screen will display OK: when the duplication

www.discmakers.com

is complete. Next to OK: will be the number of

successfully copied discs.

Note: When the duplication process is completed, the writer

drives will automatically eject the CD-Rs that have been dupli-

cated successfully. The LCD screen will display the number of

copies that are OK. If any CD-Rs have not been duplicated suc-

cessfully, the LCD screen will display the number of copies that

have FAILED. The CD-Rs that have not duplicated successfully

will remain in their drives until the eject button on the drive is

pressed. For information on why a CD-R might not copy suc-

cessfully, please see the User's Guide on the attached CD.

1-888-800-4041