Cub Cadet ZT1 42E Calibrage - Page 8
Parcourez en ligne ou téléchargez le pdf Calibrage pour {nom_de_la_catégorie} Cub Cadet ZT1 42E. Cub Cadet ZT1 42E 8 pages. Throttle position sensor (tps) calibration
Imprimer la page
17. Leave the left lap bar in the "OUTWARD"
position and move the right lap bar to the inward
"NEUTRAL" position as shown in Figure 12.
18. For the completion of the right lap bar calibration,
repeat Steps 5 through 13, then proceed to
Step 19.
19. After performing the calibration procedures for both
lap bars, test drive the mower again in a large area
in both drive modes to verify that the recalibration
is satisfactory.
If you feel that there is no difference, please contact us directly. We would like to speak to you about your feedback and
points of concern. Please send an email to
to discuss this at your convenience.
Instruction Sheet
INSTRUCTION SHEET
Right Lap Bar Inward
"NEUTRAL" Position
8 of 8
Left Lap Bar
"OUTWARD"
Position
FIGURE 12
so that we can coordinate a time
769-26105/01
DRM