Blade 350 QX2 Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Blade 350 QX2. Blade 350 QX2 18 pages.

Binding

Entering Bind Mode

Bind button

Transmitter Bind Codes

Yaw left

Yaw right

Normal Bind

Bind with GPS enabled

Bind with GPS disabled

Bind in compass calibration mode

Bind in pressure calibration mode

Mode 2 shown

Roll left

Roll right

The transmitter is bound to the model at the factory. If

for any reason the model needs to be re-bound, follow

the directions below.

The Binding Process

1. With the transmitter and quadcopter powered off,

connect the battery to the 350 QX2 AP.

2. With the 350 QX2 AP on a level surface, turn on the

power switch and allow the quadcopter to initialize.

3. Wait until the blue LED on the quadcopter ﬂ ashes

rapidly, signaling the quadcopter is initialized and

ready to bind.

4. Ensure the throttle is in the low position. Hold the

control sticks in the desired bind position

(see illustrations) and press and hold the bind but-

ton, then power on the transmitter.

5. Refer to the Flying LED Codes table to ensure the

aircraft is bound correctly.

IMPORTANT: Do not attempt to bind with more than

one bind code. Binding with more than one bind code

will only allow the aircraft to bind normally.

Unless binding with a bind code, the elevator and

aileron inputs must be neutral during binding. If you

are attempting a normal bind with any input other than

neutral, the aircraft will emit a constant, rapid beeping

sound.