Blade Scimitar LRX Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Blade Scimitar LRX. Blade Scimitar LRX 13 pages.

Imprimer la page

Connecting an Antenna

The VT1000 video transmitter includes an SMA Antenna

Adaptor which connects to the main PCB with an MMXC

connector.

Install a compatible 5.8GHz antenna onto the SMA connector.

IMPORTANT: Do not kink or cut the antenna adaptor or

antenna wires. Antenna wires are coaxial wires, there-

fore kinks or cuts will degrade performance.

Using the Video Transmitter

Consult local laws and ordinances before operating FPV

equipment. In some areas, FPV operation may be limited or

prohibited. You are responsible for operating this product in

a legal and responsible manner.

See the Available Frequencies table to find the desired video

channel and band. The video transmitter channel and band

are changed using the buttons on the top of the quadcopter,

as shown. There are two rows of LEDs visible through the LED

window. The row of red LEDs indicates the channel selected

(1–8). The row of blue LEDs indicates the selected band (A, B,

E, F, R). The green LEDs indicate the video transmitter output

power level selected.

Only change the video channel and band when the video transmitter is not transmitting a signal or is in Pit Mode. If any of the

green LEDs are glowing solid, see the directions below to stop transmitting a video signal prior to changing the channel or

band.

Channel and Band Selection

1. A short press of button B will change channels. Quickly press and release the button once for each channel until the

desired channel is reached.

2. A long press of button B will change the band. Press and hold button B for several seconds and release for each band

change.

Power Level Selection

1. Press and hold button A to change the power output. All green LEDs off means RF is off, one flashing green LED is Pit Mode, one

solid green LED is 25mW, two solid green LEDs is 200mW, three solid green LEDs is 600mW.

Tip: Use a screwdriver to access the video transmitter buttons, if you are not using the remote sensor feature on the transmitter.

Available Frequencies, North America (mHz)

Band

CH 1

FS/IRC

5740

Band E

5705

Band A

5865

Race Band

5658

Band B

5733

Preparing the Scimitar LRX Quadcopter for Flight

1. Before each flight, ALWAYS power on the transmitter before connecting the flight battery to the quadcopter. After each

flight, disconnect the flight battery from the quadcopter before powering off the transmitter.

NOTICE: Connecting the flight battery before powering on the transmitter can start the binding process. Please see the

Transmitter and Receiver Binding section of this manual for more information.

2. When the ESC beeps, the flight controller is initialized and ready for flight.

The flight controller will not arm the motors until the throttle stick is in the lowest possible position.

CH 2

CH 3

5760

5780

5685

5665

5845

5825

5695

5732

5752

5771

NOTICE: Powering on the video transmitter without

an antenna connected will cause damage to the video

transmitter. Damage from powering on the video

transmitter without a compatible antenna attached is

not covered under warranty.

Button A

Channels

Button B

CH 4

CH 5

5800

5820

5665

5885

5805

5785

5769

5806

5790

5809

Bands*

CH 6

CH 7

5840

5860

5905

5765

5745

5843

5880

5828

5847

Power

Levels

CH 8

5880

5905

5725

5917

5866