Blade CG02+ 3-Axis Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Blade CG02+ 3-Axis. Blade CG02+ 3-Axis 17 pages. Brushless camera/gimbal

Imprimer la page

DX7, DX9, DX18

In Channel Input Conﬁ guration:

• Assign Channel 7 Input (AUX2) to R Knob.

• Assign AUX1 to A.

In Servo Setup:

• Set the AUX1 travel to the values below:

140

120

To change the gimbal angle, set switch A to position 0

and adjust the angle of the gimbal by rotating the

R Knob at any time.

Using the Gimbal

1. Insert the micro SD card into the slot on the bottom

of the camera.

2. Place the quadcopter on a ﬂ at and stable surface.

Ensure there are no obstructions in the path of the

CG02 GB.

3. Switch on your transmitter.

4. Switch on your quadcopter.

ST10+ Personal Ground Station

The ST10+ requires no additional programming to use

the CGO2+. Proceed to "Using the CGO2+ With Your

ST10+ Personal Ground Station."

After the CGO2+ powers on, the LED will glow red for

approximately 40 seconds while the gimbal initializes.

When the LED changes to green the CGO2 is ready to

connect via WiFi.

See the "Using the CGO2 App" section for instructions

on how to connect your gimbal to your smart device

and for a description of the camera controls available.

The gimbal will now compensate for any roll, pitch

and yaw movements encountered by your quadcopter

in ﬂ ight.

If desired, you may change the pitch angle of

the gimbal at any time using your programmed

transmitter controls.