Discount Car Stereo JAGCD-HF Démarrage rapide Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Démarrage rapide Manuel d'installation pour {nom_de_la_catégorie} Discount Car Stereo JAGCD-HF. Discount Car Stereo JAGCD-HF 12 pages. Bluetooth kit for jaguar xk and xj with cd changer
Également pour Discount Car Stereo JAGCD-HF : Manuel d'installation (10 pages)

Imprimer la page

2. Connect 6-pin audio splitter plug (See Fig. 13) to audio cable 6-pin

connector (routed from trunk/hatch)

3. Connect audio splitter straight 3.5mm plug (See Fig. 13) to Module

input jack labeled (CD) (See Fig. 14)

Audio Jack in center

4. Connect audio splitter right angle 3.5mm plug (See Fig. 13) to module

pigtail jack (See Fig. 15)

Note: Older version of the audio splitter may have these functions reversed. If

there is no audio playback or if audio is low/distorted it's likely because these

are reversed and the right-angle plug must be connected to the "CD input

instead of pigtail jack.

Fig. 13

Audio splitter

Fig. 14

Fig. 15

pigtail jack

5. Connect microphone/push-button (See Fig. 16) to Module mic input

jack (See Fig. 14)

Fig. 16

Control button/Microphone

6. Consider where to install control button/mic. The microphone is built-

in and must be facing forward for voice commands and phone dialog

(cable is 6ft. long). We recommend completing the remainder of

the install prior to securing the button. Once settled on location,

remove tape backing (See Fig. 17) and stick to dash (See Fig. 18)

or purchase our

G2-HF

visor kit which allows microphone to be

mounted separately. See Optional Microphone/control button

installation kit at the end of this guide.