Arnica Hydra Rain PLUS Manuel d'instruction - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Arnica Hydra Rain PLUS. Arnica Hydra Rain PLUS 16 pages. Shampoo vacuum cleaner with water filter
Imprimer la page
SHAMPOO, WET & DRY VACUUM CLEANER
INSTRUCTIONS MANUAL
Thank you for choosing our product. This instructions manual
has been prepared for you to achieve complete satisfaction and
maximum performance from your product
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE
APPLIANCE AND KEEP THEM FOR FUTURE REFERENCE
CONTENTS
I. IMPORTANT SAFETY & USAGE INSTRUCTIONS
II. GENERAL DESCRIPTION
III. TECHNICAL FEATURES
IV. PREPARING FOR USE
V. USING THE APPLIANCE
VI. CLEANING & MAINTENANCE
I. IMPORTANT SAFETY & USAGE INSTRUCTIONS
• Check if the voltage indicated on the type plate sticker located
under the wheel group corresponds to the local mains voltage
before you connect the appliance.
• The appliance should only be connected to power outlets which
are suitably with minimum 10 Amp fuse.
• Do not insert the mains plug into the wall socket until the
appliance is completely ready for use.
• Always remove the mains plug from the wall socket if the
appliance doesn't operate.
• Unit shouldn't be used if the cord or plug is damaged, if any
defects are present, if you have dropped the unit or have broken
any of its parts. In such cases, you must take it to a certified
service center to be checked, repaired or adjusted.
• Do not allow the appliance to pass over the cable as this may
damage the insulating shield.
• Keep the appliance and the cleaning liquid out of reach of
children
• Never use appliance without the foam filter
• Never immerse the motor unit in water
• Never spray the shampoo at plugs, sockets or electrical appliance
• Do not attempt to use the appliance if it appears to be defective.
• Always switch the appliance off after use and remove the mains
plug from the wall socket.
• Always empty, clean and dry container after wet use. Let the
appliance suck in dry air for few minutes to dry the inside of
the tubes and hose. This prevents unpleasent smell.
• Do not point the hose at the eyes or ears nor put it in your
mouth when the appliance is switched on.
• Take particular care when cleaning stairs.
• Switch off immediately in the event of leaking liquid.
• Use only original accessories and spare parts to ensure the perfect
performance of your cleaner and to benefit from the guarantee.
• For repairs or spare parts, contact your local service agents.
• Do not operate the pump while shampoo reservoir is empty or
it is not needed to inject water or shampoo. If pump works
without water, pump temparature in increased and control part
cuts off the pump operation. Pump doesn't work in 30 minutes
before cooling.
• Always use the shampoo which is advised by manufacturer.
• Make sure that all textiles and surfaces to be cleaned are
suitable for shampooing. Especially for delicate, hand woven
carpets test a small area first and wait for checking the
result..
WARNING : Never use the appliance to clean up flammable or
explosive solvents, object soaked with such solvents, explosive
dusts, liquids such as petrol, oil, alcohol, thinners and objects
that are hotter than 60oC, as this will cause a serious explo-
sion and fire hazard! The appliance must not be used near
flammable substances and must not be used to clean up
health endangering dust.
II. GENERAL DESCRIPTION
Main parts of the appliance are shown as follows (Figure 1)
A. MOTOR UNIT
This group contains motor, pump, switch and operating units on.
Top of this group, there is a HEPA FILTER which filters dust and
other particles from blowing air. If you remove the foam filter, you
will see a large plastic float in a case. As the
container fills, this plastic float rises up and cuts off the vacuum
action to warn you when the container needs emptying.
A1 - Pump switch
A2 - On/Off switch
A3 - Shampoo hose connector
A4 - Hepa filter housing
A5 - Hepa filter
A6 - Hepa filter housing cover
A7 - Float group
A8 - Foam filter
B. CONTAINER GROUP
Container Group is the middle part of the cleaner for collecting dust
and dirty water. This group is fastened with Motor Unit using clip
locks. Shampoo reservoir which contains shampoo and clean water
is placed under the container group.
B1 - Container
B2 - Water filter body
B3 - Sponge for water filter
B4 - Water filter tube
B5 - Black seal
B6 - Clamps
B7 - Locking nest
B8 - Suction inlet
C. SHAMPOO RESERVOIR GROUP
Shampoo reservoir contains shampoo and clean water.
When pump is operated, shampoo and water is extracted from the
shampoo reservoir. Coming water from tank through water tube
is sprayed. Shampoo reservoir is located between container and
wheel group.
C1 - Shampoo reservoir
C2 - Short shampoo hose
11