DISCOVER LYNK Edge Card Victron Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DISCOVER LYNK Edge Card Victron. DISCOVER LYNK Edge Card Victron 9 pages. Lithium ion battery

Imprimer la page

5.2 Connecting LYNK to the AES Battery

Connect the AES LYNK Communication Gateway to the AES LIFePO

Gateway Users Manual.

•

Do not plug the AEBus RJ-45 cable terminator into the 10/100 Ethernet port

of the LYNK.

•

Do not connect a CAT5 cable from the 10/100 Ethernet port of the LYNK to

the WAN or MODEM port of a network router.

•

Turn OFF all devices before connecting cables or inserting an Edge Card.

•

5.3 Connecting LYNK to the Victron Network

Before connecting LYNK to the Victron Network ensure that the firmware for all Victron devices is up to date.

•

MultiPlus / Quattro - version 459 or later.

•

CCGX / Venus GX - version 2.32 or later.

•

VE.Direct MPPT - version 1.42 or later.

•

VE.Can MPPTs cannot be used and are not yet supported

Insert one end of a CAT5 communication cable into the LYNK Edge Card port and the other end into one (A) of the two

VE.Can ports (A-B) on the back of the Color Control GX (CCGX). Use the terminator provided with the CCGX to terminate the

network by plugging it into the second VE.Can port (B).

HAZARD OF EQUIPMENT DAMAGE

Failure to follow these instructions can damage equipment.

Power electronics are not AEBus devices and should not be connected

to AEBus.

Battery and power up as described in the LYNK Communication

▲ CAUTION

▲ NOTE

discoverbattery.com