DISCOVER Adapt 30 Manuel de l'utilisateur - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DISCOVER Adapt 30. DISCOVER Adapt 30 17 pages.
Également pour DISCOVER Adapt 30 : Manuel (6 pages)
Imprimer la page
How to Activate a Conference Call between two headsets:
While Headset A is on a call, press the <Mute> button on the base station (fig. 1) for more than 2
seconds. The base station is now in the 'Conference Call Initiating Mode' and all LEDs, except the
Battery Charging LED, will be flashing.
Headset A generates a Conference Beep and Headset B will get a Conference Ring Tone.
On Headset A, the user needs to press the <Mute> button on the headset (fig. 2) for more than 2
seconds within 20 seconds to accept the conference call initiating request.
On Headset B, the user needs to press the <Hook On/Off> button (fig. 3) to accept the incoming
conference call request.
Default : Headset B will be on Mute until the conference call is fully set up. User can toggle Mute
operation.
If both headsets accept the conference call request, the base station goes into 'Conference Mode'
and the <In-use> LED (fig. 4) will flash to indicate the 'Conference Mode'.
How to Deactivate a Conference Call:
While in 'Conference Mode', the user on Headset A can press the <Mute> button (fig. 2) for more
than 2 seconds to terminate the conference call and can go back to a normal single call.
User on Headset A can press <Hook On/Off> button (fig. 3) to terminate current active call.
The user on Headset B can press <Hook On/Off> button (fig. 3) to leave the conference call.
In this case, Headset A goes back to a normal call.
Mute (fig. 2) /
Speaker Volume
Hook On/Off
(fig. 3)
Answer / End a call
In-use (fig. 4) /
Busy Indicator
Microphone
Mute Button
(fig. 1)