Blake Water Solutions MOD-SOL1-BWS Instructions d'utilisation et d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} Blake Water Solutions MOD-SOL1-BWS. Blake Water Solutions MOD-SOL1-BWS 12 pages. Equipment modules

Imprimer la page

1. Table of Contents

EMULATOR MODULE

MODEL # MOD-EMU-BWS

The Emulator module comes with a male

IEP connection (Infinite Expandability

Port). Prior to start-up, first ensure all the

toggle switches for the "Module Alarms"

Emulation Module

and "Lamp Alarm" are in the OFF (toggle

up) position. Plug the Emulator connector

Days

into the IEP on the BLAKE/HO controller,

Solenoid Status

Closed

Open

then plug in the controller power cord.

Module Alarms

Sensor

Solenoid

4-20

Remote Alarm

Lamp

To Emulate a particular module failure,

toggle the corresponding switch to the

4-20 mA module

ON (toggle down) position. The alarm can

be cleared by returning the switch to its

MOD-EMU-BWS

OFF (toggle up) position. The device also

can emulate the UV intensity reported by

a UV sensor module. Turning the right "UV" knob in the clockwise direction will increase the

intensity, while turning it counterclockwise will decrease the intensity. Please note that to see

all the capabilities of the sensor, you will need to cycle the intensity through the range of 49

through 66 %. The "Days Remaining" cycle can also be adjusted by turning the left "Days" knob.

BWS5/BWS6

BWS5-C/6-C

Series controllers

IEP

connection

1 |

P a g e