ARO 8521-A Manuel de l'opérateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} ARO 8521-A. ARO 8521-A 19 pages. “o” series “qrt” screwdrivers

Imprimer la page

DRIVE SECTION

M30

ADJUSTABLE CLUTCH

CLUTCH ADJUSTMENT

Remove clutch assembly (36310) from tool. Place pin in hole of

jaw (36318) or wrench on square end of spindle (36311) to adjust

nut (36313). To adjust properly, release nut to least tension. Tight-

en nut one or two positions -each click = one position. Assemble

clutch to tool and test torque on fastener to be tightened. Repeat

until desired torque is obtained.

DISASSEMBLY

ASSEMBLY

NOTE: Lubricate balls, jaw faces, bit holder shaft, pins and thrust

pad with ARO 40036-1 grease when assembling clutch. Clutch

assembly should contain approximately 1/8 oz. (3.5 g) of grease.

a. Assemble jaw (40772) to spindle (36311) aligning face of jaw

with center of bearing groove in spindle. Assemble balls

(Y16-203) into groove and slide jaw ahead to retain balls in

groove.

a. Remove clutch housing (left hand threads) and bit holder as-

sembly (36322) from tool. Grasp clutch assembly and pull

Assemble key (36319) and jaw (36318) to spindle and secure

from gearing.

with retaining ring (37243). NOTE: Assemble jaw (36318) to

spindle with small hole in face of jaw facing jaw (40772).

b. Remove nut (36313)

releasing washer (33609) clutch

spring, pad (36316) pins (36317) and balls (Y16-205).

c. Assemble balls (Y16-205), pins (36317) thrust pad (36316)

clutch spring, washer (33609) and nut (36313). Adjust to de-

c. Remove retaining ring (37243) releasing jaw (36318) key

sired tension (see "Clutch Adjustment").

(36319) jaw (40772) and balls (Y 16-203).

d. Assemble spring (31092) plug (31093) bit holder assembly

(36322) and bit to spindle and assemble to tool. Assemble

clutch housing to tool.

BALL (16) Y 16-203

"O" RING Y 325-8

SPRING 31092,

@PIN (6) 36317

NUT 36313

BALL

Yl6-205

(6)

WASHER 336091

THRUST PLUG 310933

RETAINING RING 37243

BIT 30320-2

JAW 8 BIT HOLDER

ASS'Y 36322

GUIDE ADAPTER IS PRESSED

INTO HOUSING

SEE PAGE 14 FOR ADDlTlONAL GUIDE ADAPTERS

CLUTCH

TYPE

CLUTCH

ASS'Y. NO.

SPRING IDENTIFICATION

SPRING NO.

TYPE WIRE

WIRE THICKNESS

38310-l

HIGH TORQUE

37872

FLAT

.093" x .188"

38310

MED. TORQUE

36315

FLAT

.062" x .156"

3831 o-2

LOW TORQUE

38512

ROUND

.080" DIAMETER

PARTS

MARKED

THUS

ARE INCLUDED IN SERVICE KIT NO. 42114 AND/OR 42341, SEE PAGE 12.