BLAM CR20 Manuel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} BLAM CR20. BLAM CR20 11 pages.

Power connections

Connect the ground terminal to the closest point on the chassis of the vehicle. Keep this ground wire to less

than 39" (100 cm) in length. Use 8 gauge (or heavier) wire. Connect the remote terminal to the remote output

of head unit using 16 gauge ( or heavier ) wire. Connect an empty fuse holder within 18" (45 cm) of the car

battery, and run 8 gauge (or heavier) cable from this fuse to the amplifier location. Then connect the fuse

holder to the "BATT+".

Low-level (RCA) input wiring is preferred for best audio performance. Most trunk or hatchback installations will

require a 15-20 feet RCA cable, while pickup trucks and under-seat installations will require a 6-12 feet RCA

cable. Always use a high quality cable. Connect to remote turn-on terminal on head unit.

NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your amplifier at the

same time!

The high level input(s) should only be use If the RCA outputs are not present, connect the speaker outputs

from the receiver to the high level input connector of the amplifier. Be sure to observe polarity to avoid audio

phase problems. The ground wire can be connected to the ground of the Head Unit. The AUTO POWER ON

is for high level connexions. The subwoofer turns on automatically when there is a signal on the input.

NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your amplifier at the

same time!

To remote TURN-ON

Power

Terminal on Head

Supply

Unit

From Outputs oh

Head Unit