Discovery Labs Warming Cradle 801-000 Manuel d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Discovery Labs Warming Cradle 801-000. Discovery Labs Warming Cradle 801-000 20 pages. Dry block heater

Imprimer la page
6

Quick-Start Guide to Operation

Follow these simple steps to operate
WARMING CRADLE
®
1
Remove WARMING CRADLE and power cord from the box.
Insert power cord into WARMING CRADLE and plug
2
WARMING CRADLE into a 110 V AC electrical outlet.
•
Listen for 3 short beeps
•
Look for flashing AMBER LEDs
•
Check that the display alternates between "Preheating" and "In Process"
Verify that WARMING CRADLE has reached the
3
operating temperature of 44ºC ± 1ºC.
•
Listen for 3 short beeps
•
Look for steady GREEN LEDs
•
Check that the display alternates between "Insert" and "Vial"
When Step 3 is completed, WARMING CRADLE is preheated and ready to
warm vials. The unit should remain plugged in between uses to maintain the
preset temperature of 44°C
4
Open the dust cover and insert vial(s).
•
Look for alternating AMBER and GREEN LEDs
•
Check that the display alternates between "Warming" and "Vial"
Note:
– The factory preset time is 15 minutes
– The "Warming Vial" cycle will run the full 15 minutes, irrespective of the vial
starting temperature
– WARMING CRADLE automatically detects when a vial is inserted
and will start the timer on the display
– The temperature may briefly drop 2°C to 3°C when a cold vial
is inserted
– After 14 minutes of warming, a 2-tone signal will sound once, to let
you know that the warming cycle is almost complete
At 15 minutes, verify that the warming cycle is complete.
5
•
Listen for a 2-tone signal that sounds repeatedly
•
Look for flashing GREEN LEDs
•
Check that the display is flashing "Complete"
6
Remove the vial(s).
Dry Block Heater 801-000.
±
1°C and be ready to use at all times.