3D LabPrint Avion Airplanes Duck Manuel de l'utilisateur - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 3D LabPrint Avion Airplanes Duck. 3D LabPrint Avion Airplanes Duck 13 pages.
Imprimer la page
Avion
airplanes
Completion
You will need
Canopy, W_L_3_Cover, W_R_3_Cover,
ø2x385mm carbon rod 2x (elevons axles),
Steel wire, carbon rod or clevis (pushrods)
CA glue
1.
Use
ø2x385mm
carbon rod 2x
as
elevons axles.
Don't insert them
all the way in at
this point in case
that you will need
to make pushrods
or other
adjustments.
2.
Set elevons to neutral
position and install
pushrods. Make sure,
that everything moves
freely. If not, use sand
paper or drillbit and
make necessary
adjustments.
DUCK user manual
Completion
3.
If everything moves
freely and pushrods
are installed correctly,
insert
ø2x385mm car-
bon rod 2x
all the way
in and secure them
with small drop of CA
glue to the elevons.
4.
Install
RX
and battery. Now you
are ready to start programming
servos and set right CG.
f
I
Avion Airplanes
avion_airplanes
22