Dish Network DISH Player-DVR 522 Configuration de la télécommande - Page 5
Parcourez en ligne ou téléchargez le pdf Configuration de la télécommande pour {nom_de_la_catégorie} Dish Network DISH Player-DVR 522. Dish Network DISH Player-DVR 522 17 pages. Dish network remote control setup guide
Également pour Dish Network DISH Player-DVR 522 : Manuel de l'utilisateur (1 pages), Pour commencer (2 pages)
Imprimer la page
222.book Page 61 Tuesday, July 25, 2006 1:30 PM
Installing a UHF Attenuator
Unwanted UHF signals may interfere with signals from the remote control to the receiver.
To prevent such interference, you can install a 10 dB attenuator (available from many
consumer electronics parts stores). Adding this attenuator will help keep out stray UHF
signals, but it also cut down how far away you can use the remote control.
1
2
3
C
ONTROLLING
To use the remote to control other devices (such as a TV, VCR, DVD player, tuner,
amplifier, or DISH Network satellite receiver), you must first program it to control these
other devices. You can do this by either following the instructions in Setting Up Using
Device Code Tables on page 63, or the Setting Up Using Device Codes Scan procedure
described on page 64.
Remove the UHF antenna from the UHF Remote
Antenna input on the receiver back panel.
Attach a 10 dB attenuator to the UHF Remote
Antenna input.
Attach the UHF antenna to the attenuator.
O
C
THER
OMPONENTS
Remote Controls
Controlling Other Components
61