Dish Network DuoDVR ViP 622 Manuel de l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dish Network DuoDVR ViP 622. Dish Network DuoDVR ViP 622 17 pages. Receiver and remote controls
Également pour Dish Network DuoDVR ViP 622 : Configuration de la télécommande (17 pages)
Imprimer la page
Chapter 2
Remote Control
Types of Remote Controls
Remote Control 1 uses infrared (IR)
signals to:
•
Control TV1 menus for the nearby
TV in Dual Mode.
•
Control the satellite receiver in
Single Mode.
IR signals travel only short distances
(60 feet or less), and cannot go
through walls or other solid objects.
You must point the remote control
directly at the receiver, with no objects
blocking the line of sight.
Remote Control 1 uses IR signals
to control the receiver and other
devices it is programmed to operate.
This remote control is identified by the
green number 1 at the bottom of the
remote control.
16
1
2
UHF
PRO
Remote Control 2 uses UHF Pro
signals to:
•
Control TV2 menus for the remote
TVs in Dual Mode.
•
Control the satellite receiver in
Single Mode.
UHF Pro signals travel long distances
and go through walls and other solid
objects.
To use Remote Control 2 to control
the receiver, you must attach the
remote control antenna to the receiver
back panel (see page 17).
Remote Control 2 uses IR signals to
operate other devices programmed
into the remote control. You must
point the remote control directly at
these devices, with no objects
blocking the line of sight.
This remote control is identified by the
blue number 2 at the bottom of the
remote control.