Acoustic B810 Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Acoustic B810. Acoustic B810 16 pages. Bass guitar amp heads and cabs
Également pour Acoustic B810 : Manuel du propriétaire (8 pages)

Acoustic B810 Manuel de l'utilisateur
B600H
1
2
3
4
1. 1/4" Passive input – use for bass guitars with passive pickups.
2. 1/4" Active input – use for bass guitars with active pickups. This input is -10dB from the passive input.
3. Mute switch – push button in to activate mute circuit. The red light will come on.
4. Gain control – set so clip indicator is not lit, otherwise distortion may occur.
5. Volume level control – set to your desired volume level. If distortion occurs, reduce volume level.
6. Active -10 dB notch at frequencies from 50Hz to 1kHz - approximately 250Hz with the frequency knob at
12 o'clock. Notch on/off switch is foot-switchable.
7. Active low frequency control – set to boost (+12 dB) or cut (-12 dB) frequencies centered around 63 Hz.
8. Active low-mid frequency control – set to boost (+12 dB) or cut (-12 dB) frequencies centered around 150 Hz.
9. Active low-mid control – set to boost (+12 dB) or cut (-12 dB) frequencies centered around 350 Hz.
10. Active high-mid control – set to boost (+12 dB) or cut (-12 dB) frequencies centered around 800 Hz.
11. Active high frequency control – set to boost (+12 dB) or cut (-12 dB) frequencies centered around 2 kHz.
12. Active high frequency control – set to boost (+12 dB) or cut (-12 dB) frequencies set centered around 5 kHz.
13. On/Off light - when this jewel light is lit, your amp is on and ready to be played.
14. Power switch - turns amp on or off.

rEAr pANEl lAyOuT

B200H
1. Speaker Out: Two-conductor, 1/4" Speaker Output Jacks, 4 Ohms minimum
load, parallel.
2. Effects Loop Send & Return: Unbalanced, 1/4" Line Output Jack. These jacks
will allow a signal to be sent to an external effects device or equalizer, then
patched back in before the power amp section.
3. Direct Out with Volume Control: This sends a line-level signal to a PA system
or recording device. Use the Direct Out Volume knob to prevent clipping.
4. Ground Lift Switch: Lifts ground on pin 1 on XLR.
8
w w w . a c o u s t i c a m p l i f i c a t i o n . c o m
13
5
6
7
8
9
10
11
12
3
1
13
14
4
2