3D Systems CubeX Remplacement de la pointe d'impression - Page 3
Parcourez en ligne ou téléchargez le pdf Remplacement de la pointe d'impression pour {nom_de_la_catégorie} 3D Systems CubeX. 3D Systems CubeX 7 pages.
Imprimer la pageUnplug the print tip from the Print jet sensor board and feed the wire down the hole to the print tip.
3
Unfasten the print tip holding bolt.
4
The print tip and print jet are assembled by sliding the print tip into the print jet and twisting it (as
pictured).
5
To remove the print jet you will need to twist it and pull down, eventually you will find the correct
orientation and the print tip should easily slide out.