Aerial DS 40 Manuel d'instruction - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Aerial DS 40. Aerial DS 40 16 pages. Air dehumidifier

Use the hygrostat (Fig. 2 and Fig. 3, item 11) to set the desired humidity. During

setting. the selected humidity value is indicated in the display (Fig. 2, item 1 /

Fig. 3, item 9). After setting, the current humidity is displayed in per cent.. If the

existing humidity is higher than the set value the device will start.

If required, set the fan speed using the button (Fig. 2 and Fig. 3, item 8).

The device-on lamp is on when the device is switched on.

Via the timer (Fig. 2, item 2 / Fig. 3, item 10) the device can be

activated for up to 24 hours (0 to 24), as required. In case of

humidity values above the set value the device will operate

continuously up to the end of the set time. To switch off the timer

set the timer to "0".

When the tank is full the pilot lamp (Fig. 2, item 6 / Fig. 3, item 2) lights up and the

device stops working.

Switch the device off and empty the tank. After the tank has been put back into

the device switch the device on again..

After the tank has been emptied, the device remains set to the

humidity value previously set, the timer is automatically switched

off.

Maintenance and service

Danger of injury by electric shock and risk of material

damage

WARNING

 Always observe the safety instructions when performing

 Switch the device off and pull the power plug before

Danger of injury due to sharp-edged lamellae

 Wear protective gloves during cleaning.

WARNING

any maintenance and service work!

cleaning and inspection.

B – 9