3D Systems ProJet 5500X Manuel de démarrage rapide - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} 3D Systems ProJet 5500X. 3D Systems ProJet 5500X 13 pages.

Imprimer la page

8/11/22, 10:07 AM

Printer Startup and Demo Build

The purpose of this section is to execute the following:

Power the printer on.

Load support and part material cartridges into the material delivery modules.

Install a build platform.

Perform a successful Demo build.

Remove the nished parts from the printer.

Empty the waste drawers.

Switch the printer off.

Completion of this process will familiarize you with all of the "basic" printer operations

needed to build parts on the ProJet 5500X and provides a functional "shakedown" for a new

installation. It is strongly recommend that you complete this section before moving on to

larger more sophisticated builds.

Power the Printer ON.

1. Connect

power cord

2. Place

power switch

3. Wait 4 hours for printer to warm up before attempting to start a build job.

4. Because the materials also require a warm up period, proceed to the next step of adding

material

to the

NOTE: Build les can not be submitted to the printer while it is warming up.

infocenter.3dsystems.com/projetmjp5500x/print/book/export/html/966

to the printer (A) and plug into facility receptacle.

(B) located at the rear of printer, to the

material delivery

modules.

Quick Start Guide

position.

5/13