Aeris 3Dee Manuel rapide - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Aeris 3Dee. Aeris 3Dee 2 pages. Active office chair
Également pour Aeris 3Dee : Assemblage et réglages (2 pages)

Imprimer la page

Important Information

Congratulations! With the 3Dee you have made a choice for active sitting.

Move in all directions and test the different adjustment options. You can

change the adjustments as required.

assemble and adjust your 3Dee.

Assembly

1. Slot all the castors into the upturned base. 2. Loosely insert the spring strut

into the opening of the base. Hold the rubber ring on the base with one hand

and with the other hand slowly turn the spring strut until you feel it fall into

place in the base. 3.1 Place the seat opening on the gas spring. 3.2 Hold the

spring strut with one hand and with the other hand turn the seat until you feel it

fall into place.

3.3 IMPORTANT: Make sure that the white arrows under the seat

are aligned with each

other.

Then sit on the seat and bounce up and down

forcefully a few times so that the connections can no longer separate.

Secure the chair against rolling away. 4.2 Slot the backrest slowly and perfectly

straight into the opening until you hear it click into place and you can no longer

pull it out again. 4.3 Screw the backrest tight with the screws and Allen key

provided.

Settings

A. Height: You adjust the height using the lever under the seat. The open angle

of your legs (thigh to lower leg) should be just over 90°. B. Spring: You can

adjust the vertical bounce. The optimum setting is when you can move freely

up and down without reaching the bottom stop. We recommend that you

carefully turn over the chair and lay it on the backrest. Screw the sleeve on the

spring strut to the left – for maximum vertical movement/ low weight. Screw the

sleeve to the right (observe STOP mark!) – for reduced vertical movement/

more weight. C. Flexible sideways movement: Carefully turn over the 3Dee and

lay it on the backrest. Turn the handwheel to the left for more flexibility and to

the right for less flexibility. We recommend starting off with a setting for

reduced sideways movement and later adjusting the setting to provide as

much sitting movement as possible. D. Backrest tension: Turn the butterfly nut

to the left in the "–" direction (about 10 – 15 times) for a softer setting with less

tension. Turn the butterfly nut to the right in the "+" direction (about 10 – 15

times) for a harder setting with more tension. E. Lumbar support: Sit on the

chair without resting against the backrest and grasp the adjusting bar of the

backrest left and right with both hands. Press the lever on the inside on the

right and move the adjusting bar up or down into the required position.

Notes

Disassembly: Possible only at the factory. Work on or replacement of the gas

spring must be carried out by a trained specialist only. Care Instructions:

Available at www.aeris.de. Guarantee: We grant a guarantee of three years

from the date of purchase for purchases directly from an authorised aeris

dealer. Load: Maximum load 120kg | 265 lbs. Video: For assembling and

adjusting: www.aeris.de/en/service/assembly-videos/

Make sure that you use a soft surface to

Below are a few hints to help get you started.

3.1

4.1

3.3

4.3

3.2

4.2