3DGence DOUBLE P255 Manuel d'entretien - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} 3DGence DOUBLE P255. 3DGence DOUBLE P255 19 pages.

Prepared models .stl and .gcode are also available at

www.3dgence/support

in the tab Your files

(the tab is available after creating an account and registering the device).

After printing, cooling down and removing the calibration cross carefully from the heatbed, measure the cross along

X and Y axes. They are marked on the model. Different tools can be used to make the measurement, but their

accuracy must be at least 0.05 mm:

• slide caliper,

• micrometer,

• coordinate measuring machine,

• optical tools.

The printout should be measured along X and Y axes. To increase the measurement certainty, follow the below

instructions:

• the measuring point should be in the middle of the model height above the step, both points at the height of the

same layer (fig. 59),

• measurements for X and Y axes should be made 5 times for each axis. Reject the highest and the lowest

measurement result from each group. Other measurements should be averaged for each axis (fig. 60).

3DGence DOUBLE P255 - maintenance activities | version 07.2021