CAME 001CS1PLCO Manuel d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} CAME 001CS1PLCO. CAME 001CS1PLCO 16 pages. Audio entry kit
Également pour CAME 001CS1PLCO : Manuel d'installation (16 pages)

Imprimer la page

Connection example K

001DC002AC

Programming

The kit is pre-configured to manage a single call originating from a single entry panel. One or more receivers answering the same call can be

added, by following the below "Call button programming" procedure.

Initial programming

PROG

SW3





– +

–

VLS/300

001DC005AC

Entering Programming Mode. Press the PROG a key for at least 3 seconds and then release it

>3''

(within 6 seconds), as soon as the LED PROG lights up and the key back lighting flashes as illustrated

<6''

in figure . Failure of the PROG LED to light up, indicates a malfunction. Check the connections and

re-access the programming mode.

Programming of the Key Type. Press the first key of the entry panel in the position indicated c/

cA until the backlighting LED stops flashing  and remains lit.

PROG

SW3

Programming the call keys. Lift the receiver (if present) of the extension that you want to programme

BOUT

e then press the door lock release

key to associate with the internal extension g: an acoustic signal will confirm that the setting was

PROG

stored. Hang up the receiver again, if necessary h and continue, repeating the same operations for

the other extensions.

SW3

–

BOUT

and AUX2 f buttons. On the entry panel, press the call

c A

BOUT

beep

PROG

SW3