Acoustic Research AW-811 Manuel d'installation et d'utilisation - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Acoustic Research AW-811. Acoustic Research AW-811 12 pages. 900mhz wireless indoor/outdoor speaker
Imprimer la page
Warning:
This product is designed to work with line level outputs or
headphone outputs only. DO NOT connect it directly to speaker outputs as it
will permanently damage the transmitter.
III. Powering the Speaker
There are two options to power your wireless speaker:
i. AC Power Adapter:
Speaker
Speaker power
input jack (C)
Warning:
This product is water resistant, not waterproof. To avoid electrical
shock, it should be used with caution near water sources if powered with the
AC adapter. Never submerge in water.
ii. C-cell Batteries:
Important:
If you are using NiMH or NiCd batteries, the batteries will charge when the
headphones are powered with the AC power adapter. Do not power the head-
phones with the AC power adapter if you installed alkaline or other non-re-
chargeable batteries—this could cause the batteries to leak. Do not mix batter-
ies with different chemistry types (for example, a zinc battery with an alkaline
battery). Do not mix new and used batteries. Do not leave batteries installed in
the product when not in use for long periods.
Sortie audio
AC Power
adapter (M)
120 V AC
Wall
Outlet
Battery
compartment
cover (G)
AW811
1. Turn the speaker volume down by
rotating the power/volume/scan
control (B) on the side of the
speaker all the way to the left.
2. Insert the small, round plug from the
speaker AC power adapter (M) into
the speaker power input jack (C).
3. Plug the other end of the speaker
AC power adapter into any
standard 120V AC wall outlet.
Note:
Be sure to use the speaker
AC power adapter rated 18V DC
700 mA.
1. Turn the speaker volume down by
rotating the power/volume/scan
control (B) on the side of the
speaker all the way to the left.
2. Remove the battery compartment
cover (G) on the bottom of the
speaker.
3. Insert eight (8) C-cell batteries (not
included) into the speaker
following the polarity ("+" and
"–") as diagrammed inside the
battery compartment.
Note:
Place the rubber cap in the
speaker power input jack (C) when
using batteries.
4