Altman Phoenix Series Manuel d'utilisation, de programmation et de sécurité - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation, de programmation et de sécurité pour {nom_de_la_catégorie} Altman Phoenix Series. Altman Phoenix Series 12 pages. Ellipsoidal spotlight
Également pour Altman Phoenix Series : Manuel de démarrage rapide (4 pages)
Imprimer la page
YOKE & SHUTTER ASSEMBLY
Short Yoke
Position
T-Handles
Yoke Bolts
Cup Washers
Pivot Covers
Shutter Assembly
ROTATING SHUTTER ASSEMBLY
1. Loosen shutter rotation lock knob on either side of
the fixture.
2. Rotate shutter assembly 360° in either direction.
3. Tighten shutter rotation lock knobs to secure shutter
assembly.
4. To lock the shutters in place, rotate the Shutter Lock
Lever until proper tension is applied to shutters.
***SHUTTER ASSEMBLY SCREW GUIDES
These two screws prevent the shutter assembly from coming off the light engine while rotating.
Only remove these screws when taking the light shutter assembly off of the light engine. After
replacing the shutter assembly, replace these two screws to avoid injuries.
Altman Lighting, Inc.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. COPYRIGHT 2012© ALTMAN LIGHTING, INC/ ALL RIGHTS RESERVED
Shutter Rotation
Lock Knob
***Shutter Assembly Screw Guides
Shutter Handle
57 Alexander Street., Yonkers, NY 10701
1/24/14 rev:C
USING SHORT YOKE POSITION
1. Remove T-Handle and its
associated hardware.
2. Remove yoke bolts, cup washers
and pivot covers. Note: use a 1/4:
hex head wrench to remove yoke
bolts.
3. Stretch yoke and snap it into short
yoke position.
4. Replace pivot covers, cup washers
Lens Tube
and yoke bolts.
5. Replace T-Handle into square
hole, keeping the washer between
handle and yoke.
ADJUSTING YOKE
1. With one hand on ring handle to
hold unit, loosen T-Handle.
2. Tilt unit to desired angle. Note: Ref-
erence angles have been ,molded
on the pivot cover to make adjust-
ments easier and more precise.
3. Tighten T-Handle to secure fixture
in place.
4
INSTALLING C-CLAMP
The C-clamp is used to
mount the fixture to a
pipe hang position. The
C-clamp attaches to the
top of the yoke via the
1/2" bolt provided with
the C-clamp. Be sure to
keep the washer
between the bolt head
and the yoke.
1-800-4-ALTMAN