CAME BPT MTMA/GSM Manuel de programmation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de programmation pour {nom_de_la_catégorie} CAME BPT MTMA/GSM. CAME BPT MTMA/GSM 16 pages. Audio gsm module for modular plate

Imprimer la page

• The telephone numbers in the contacts list (maximum 1000) can be authorised to command relays on board and/or associated

with the call keys; for example, it is possible to call the module from a number (that has the correct authorisations) to operate

the solenoid lock or the entry panel's on-board relay.

• The MTMAGSM module combined with the MTMKB module makes available up to 2000 codes to manage the activation of

door releases and relays; it is also possible to associate a customised call code with each group.

COMMISSIONING THE DEVICE

Preliminary operations

Note: The micro-SIM card (not included) must be enabled for 2G data traffic and for sending and receiving SMS messages.

Check the availability and costs of these services with your mobile phone operator.

Note: Make sure that module MTMAGSM has no power and that the SIM card's PIN code has been disabled.

Before inserting the micro-SIM card into module MTMAGSM, it is advisable to test the sending and receiving of SMS messages by

using the micro-SIM on a normal mobile phone, in the proximity of the area in which you intend to install the device.

Module start-up

Insert the micro-SIM card into its housing as shown in the installation instructions.

Connect the external aerial to the module socket and power the system.

During start-up all the call button LEDs flash at the same time; calls cannot be made during this stage. The module is ready for

optimum operation only once registration has been completed, and where there is a good GSM signal.

Call the telephone numbers associated with group 4.

Call the first number in group 4, if there is no answer,

call the second number in group 4, if there is no answer, etc.

Call the telephone numbers associated with group 6.

Call the first number in group 6, if there is no answer,

call the second number in group 6, if there is no answer, etc.

Checking connection to GSM network status

Press and hold down the PROG button; the LED above the button provides

the following signals:

Flashing quickly (< 2 seconds) =

Flashing slowly (> 2 seconds) =

Module not registered with network

Module registered with network