Alto CS 1020 DE Manuel d'utilisation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Alto CS 1020 DE. Alto CS 1020 DE 20 pages.

4.2

Putting into Operation

Prior to putting the machine into operation, cut off neck on oil filler plug.

Prior to starting with the Honda engine, read the Honda Operating Instructions!

Machine is supplied with an empty fuel tank.

Fill the fuel tank with fuel oil EL or Diesel oil DIN 51 603 (to be done on cold machine only!). The fuel oil must

be free from any impurities .

Additives tank (special accessory) is to be filled with Wap Cleaning and Care Agents, in the prescribed dilution(s)

. Open water tap. During the winter season, the machine will be supplied with an antifreeze in its water system.

For purging and de-aerating of the system, switch is to be turned on 'piston pump', the drive motor to be started,

and the machine allowed to run for about 1 minute. Stop machine. Refer Honda Operating Instructions.

Connect high pressure hose to spray lance. Be careful about the nozzle size, refer 2.5 - Nozzle Table.

To note:

The spray jet is likely to cause injuries whenever being handled inattentively and inexpertly. (Never direct the jet

against persons!) During the machine's operation, recoil forces do occur at the spraying device (spray lance) , with

bent spray lance, there will be torgue additionally.

4.3

Operation

Unlock, and actuate, trigger gun on/off, put switch on 'piston pump', start the drive motor.

Hot Water:

(Level I) - refer Technical Data 2.4 -

Unlock, and actuate, trigger gun on/off, put switch on 'piston pump' , start drive motor. If a uniform jet emerges

from the high pressure nozzle , putt switch on 'burner'.

(Level II) -refer Technical Data 2.4 -

Exchange standard spray lance against the steam jet spray lance, ref. no.14786. Turn thermostat to stop (steam

jet) .

Pressure and quantity control to be opened anti-clockwise.

Unlock, and actuate, trigger gun on/off, put switch on 'piston pump' , start drive motor. If a uniform jet emerges

from the fan ja nozzle, then put switch on 'burner'.

trigger gun on/off with spray lance straight (standard

version) or bent (special version)

trigger gun on/off with coaxial spray

lance(special version)

steam jet spray lance

coaxial spray lance

turn handle clockwise =

full water quantity and full pressure

turn handle anti-clockwise =

reduced pressure at full water quantity