3Doodler Create+ Manuel de l'utilisateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 3Doodler Create+. 3Doodler Create+ 16 pages.
Également pour 3Doodler Create+ : Manuel de l'utilisateur (11 pages)
Imprimer la page
3C. Plastic may be wrapped
around the Drive Gear.
Remove Maintenance Cover
using Mini Screwdriver
provided in the box.
utlet?
Use the Mini Screwdriver
or Unblocking Tool to lift
ase
and release Plastic from the
mine if
Drive Gear and out of the Pen
Power
through the open area beneath
the Maintenance Cover or
from the Plastic Loading Port.
4. My Plastic is leaking from
Nozzle may loosen with
continued usage (or in transit).
While Pen is hot (BLUE or
rol
GREEN Light on), gently turn
dler
Nozzle clockwise to tighten
it using the Mini Spanner
it
provided. Stop tightening once
you first feel resistance so as
is
to avoid over-tightening the
le.
Nozzle and breaking it.
5. My Plastic won't stop extruding.
A. Click either the FAST or SLOW button once.
B. If Step A does not solve this problem, please unplug your
3Doodler Create+ and then plug it in and try again.
6. How do I reverse my
While the Pen is on and hot (BLUE or GREEN Light), double click
either the FAST or SLOW button. Light will start flashing to signal
the Plastic is reversing. Once the Plastic stops reversing, it is safe
to remove it from the Pen by gently pulling on the back of the
strand.
If Plastic is too short to reverse, see Section 3, Step 3B.
from
7. I have reversed my Plastic but
:
It is possible that the Plastic is either too short to reverse all the
way out of your 3Doodler Create+, or that the Plastic has moved
Drive
past the Pen's Drive Gear system.
You will be able to check for these issues by looking through the
the Pen.
Maintenance Cover.
ain.
to 3B.
Plastic reversed, but too short to take out and no longer in
contact with the Drive Gear.
Plastic is beyond Drive Gear.
For both of these issues, you can try the following options:
• Insert a new strand of Plastic or Unblocking Tool to push the
Blue or
Green
remaining Plastic through while Pen is ON and extruding.
Light
king
Or
• While using the Reverse feature of the 3Doodler Create+, remove
Nozzle and use Unblocking Tool to push Plastic out the back of
the Pen. (See Section 3, Step 3B).
3Doodler_Bob_User_Manual_MAIN_Inner_20180511.indd 10
around the Nozzle.
unused Plastic?
Snip the ends of your Plastic now for easier loading
TIP
and Doodling later.
cannot get it out.
Unblocking Tool
Mini
Screwdriver
Maintenance
Cover
10
Mini
Spanner
11/5/2018 11:37 AM