Diversified Power International Accusense Charge Series Manuel d'instruction - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Diversified Power International Accusense Charge Series. Diversified Power International Accusense Charge Series 14 pages. Fully automatic battery charger

Imprimer la page

7.3. STAGE THREE - CONSTANT VOLTAGE CHARGE (Absorption

Charge)

7.3.1. Yellow L.E.D. remains illuminated continuously, but the charger

now regulates voltage and not current. While the charger

maintains a constant voltage, the charge current gradually

decreases.

7.3.2. When the charger has determined the battery pack has reached

80-90% capacity, the Yellow and Green L.E.D.s both illuminate.

7.3.3. This stage ends when the charge is replenished to 100%

capacity.

7.4. STAGE FOUR - CHARGE COMPLETE (Standby)

7.4.1. Green L.E.D. only, illuminates continuously. The charger will

also disconnect itself from AC power, thereby saving energy and

cost. While connected to the battery, the microprocessor

remains active to monitor battery voltage and to keep a record of

elapsed time. The charger's DC cord set can now be

disconnected from the charging receptacle by grasping the plug

body or handle and pulling the plug straight out of the

receptacle.

7.5. RECYCLE CHARGE STAGE FIVE

7.5.1. Only after the completion of Stage 4, and after 14 days of time

has elapsed, AND if the battery voltage falls below 48Vdc, the

charger will reset itself; thereby automatically initiating a new

charge cycle routine and restoring battery to full capacity.

• If the charger is left connected to AC Power, and then the DC cord set

plug is re-connected to another battery pack, the charger will restart a

new charge cycle from the beginning (Stage 1).

• If, during any part of the 5-Stage Charge process, AC power should

happen to be disconnected, the microprocessor will momentarily stop

its program and wait for restoration of AC power. Thereafter, charging

will resume from where it left off.

• If, while charging, the charger finds an abnormal charge condition, it

will attempt to shutdown and indicate the 'Condition' by flashing one

or all of its RED L.E.D.s. Refer to the 'Troubleshooting' section for a

description of the Charge Error Condition, if you encounter a flashing

RED L.E.D.