Acoustic Research HTB80 - Acoustic Research "All-in-One" Virtual Surround Sound Speaker System Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Acoustic Research HTB80 - Acoustic Research "All-in-One" Virtual Surround Sound Speaker System. Acoustic Research HTB80 - Acoustic Research "All-in-One" Virtual Surround Sound Speaker System 6 pages. Safety guide

Imprimer la page

L/fcollslic

~s(1arch,

HTBaO

System Operation

Power On

1. Connect the DC adapter to the DC IN connector on the back of the unit.

2. Plug the DC adapter into an AC power outlet.

3. Tum the unit on using the POWER switch on the back of the main unit.

Standby

Press the STANDY button on the front panel or remote control to enter "Standby"

mode.

Selecting Input

Press the INPUT button on the front panel to access sources connected to the following

auxiliary inputs: AUX1, AUX2, or AUX3. (see "Back Panel Controls/Connections"

on page 5).

Press the AUX1, AUX2, or AUX3 button on the remote control to access the

corresponding source directly.

Volume Adjustment

Press the VOL - or VOL + button on the front panel or remote control to adjust the

volume.

Press the SUB - or SUB + button on the remote control to adjust the subwoofer

volume.

Mute

Press the MUTE button on the front panel or remote control to silence the volume.

Press MUTE again to resume the previous volume setting.

Setting the Clock

1. Press the SET button on the remote control. The hour in the clock display will

flash.

2. Press the ... or ... button on the remote control until the correct hour is displayed.

3. Press the SET button on the remote control. The minutes on the clock display will

flash.

4. Press the ... or ... button on the remote control until the desired minute setting is

displayed.

page 6

Using the Remote Control

Remote Control Functions

1. Power/Standby: Tum the unit on/off

2. AUX1, AUX2, AUX3: Press to

access the source connected to the

corresponding inputs on the back of

the unit (see "Back Panel Controls/

Connections" on page 5).

3. EFFECT: Press to enable/disable the

3D sound effect.

4. SET: Press to set the clock hours.

Press again to set the clock minutes.

5. SUB + / SUB -: Press to adjust the

subwoofer volume up/down.

6. Mute: Press to mute (silence) the

master volume. Press again to

resume audio output.

7. ... / ... : Press after using the SET

button to adjust the time.

8. VOL + / VOL -: Press to adjust the

master volume up/down.

Install/Replace the Battery

The remote control uses a pre-installed lithium battery.

Before using the remote control, pull to remove the

insulating strip.

If the remote control begins to fail, replace the battery with

another of the same type. When installing the new battery,

make sure the

"+"

sign is facing upward.

NOTE: Please discard the used battery properly.

Do not place in or near fire.

page