Esel EL-2703 Manuel d'instructions d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Esel EL-2703. Esel EL-2703 14 pages. Wireless supervised photoelectric smoke detector

Imprimer la page

INSTALLATION

The smoke detector is to be mounted on the ceiling or on the wall, if necessary. Since

the smoke detector is a single-station type, it cannot be linked to other detectors.

WARNING:

Do not connect the smoke detectors to any other alarm or auxiliary device.

Connecting anything else to this detector will prevent it from working properly.

Read the "Where To Install Your Smoke Detector" and "Where Not To Install Your

Smoke Detectors sections in this Manual before installing. To install the detector,

perform the following steps (see Figure 7).

Registration

The EL-2703 must identify itself to the EL wireless system receivers as follows:

Set the system to registration mode.

Open the detector housing.

Insert the batteries into compartment. The detector enters registration

mode during which a transmission is sent every few seconds. You can

terminate registration mode by pressing the Test Button. Test mode is

automatically terminated after approximately five minutes.

NOTE:

Due to the occurrence of voltage delay in lithium batteries that have been in

storage, the batteries may initially appear to be dead. In this case, leave the unit

in Test mode for a few minutes until the battery voltage level is stabilized.

As soon as 'Save?' appears, press '√'

Wireless Supervisor Photoelectric Smoke Detector

Go to the main menu and select [9]>[1]>[1]

(Programming > Devices > Zones)

Select a zone and press '√'.