Alto-Shaam 100-HSL/BCB-2 Manuel d'installation, d'utilisation et d'entretien - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Alto-Shaam 100-HSL/BCB-2. Alto-Shaam 100-HSL/BCB-2 16 pages. Hot carving shelf, electric
Imprimer la page
UNPACKING and SET-UP
The Alto-Shaam Carving Shelf has been
thoroughly tested, checked for calibration, and
inspected to insure only the highest quality unit
is provided. When you receive your unit, check
for any possible shipping damage and report it at
once to the delivering carrier. See
Transportation Damage and Claims section
located in this manual.
The carving shelf, complete with unattached
items and accessories should be checked to
ensure all the following items have been received
as standard with each unit.
4: 1" (25mm) Legs
4: Nylon Screws
1: Cutting Board
2: Lamps
4: Sneeze Guard Mounting Screws (some models)
Save all the information and instructions
packed inside the carton. Complete and return
the warranty card to the factory as soon as
possible to assure prompt service in the event of
a warranty parts and labor claim.
Alto-Shaam hot carving shelves are designed
for the purpose of maintaining hot food at a
temperature for safe consumption. The unit
must be installed on a level surface in a location
that will permit the equipment to function for its
intended purpose and allow adequate access for
proper cleaning and maintenance.
The carving shelf must not be installed in any
area where it will b affected by steam, grease,
dripping water, high temperatures, or any other
severEly adverse conditions.
NOTE: All claims for warranty must include the full
model number and serial number of the unit.
HEATING CHARACTERISTICS
The shelf is equipped with a special, low-heat-density, heating cable. Through the Halo Heat
concept, the heating cable is mounted against the top surface of the shelf to provide an evenly
applied heat source, controlled by a
Through even heat application, the quality of a food product is maintained up to as much as several
hours.
H O T C A R V I N G S H E LV E S
®
E L E C T R I C A L I N S TA L L AT I O N
thermostat.P
#802/1 Operation & Care Manual •
1. An identification tag is permanently mounted
on the unit.
®
2. If necessary, a proper receptacle or
permanent wiring for this unit must be
installed by a licensed electrician in
accordance with applicable local
electrical codes.
3. Plug the unit into a properly grounded
receptacle ONLY, positioning the unit so the
power supply cord is easily accessible in case
of an emergency.
ENSURE POWER SOURCE
MATCHES VOLTAGE STAMPED ON
NAMEPLATE OF UNIT
For 230V units: To prevent an electrical shock
hazard between the appliance and other
appliances or metal parts in close vicinity, an
equalization-bonding stud is provided. An
equalization bonding lead must be connected to
this stud and the other appliances / metal parts
to provide sufficient protection against potential
difference. The terminal is marked with the
following symbol.
NOTE: The appliance must be connected
to an electrical circuit that is protected by an
external GFCI outlet.
1.
PH
3521030
PATENT NOS.
4595247