ClearChoice Premium Series Manuel du propriétaire et manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et manuel d'installation pour {nom_de_la_catégorie} ClearChoice Premium Series. ClearChoice Premium Series 7 pages. Under sink drinking water system

Imprimer la page

Congratulations on the purchase of your ClearChoice™ Premium Under Sink Drinking Water

System.

This filtration system uses premium quality activated carbon filters rated at 0.5 microns to remove

fine sediments, chlorine, and organic contaminants responsible for poor water taste and odor. It is

also capable of removing a wide variety of potentially harmful trace contaminants, including many

forms of pesticides, herbicides, volatile organic compounds, turbidity and sediments, asbestos,

mercury, and lead. It may also be used to filter certain cysts like Cryptosporidium and Giardia

which are responsible for waterborne illness.

You can rest assured that you have made a solid investment in the quality of your drinking

water!

INSTALLATION

We recommend that you read the entire instructions before commencing the actual

installation.

Note: The maximum recommended operating water pressure is 80 PSI. If your home water

pressure is greater than 80 PSI, you should have a pressure reduction valve installed by a

certified plumber prior to installing this product.

Step 1. – Pre-Installation Inspection

Inspect all of the components that you received with your unit. You should have received the

following:

• 2-stage filtration unit assembly with mounting bracket (this is pre-assembled)

• chrome-finished long-reach faucet and hardware

• water tubing

• quick connect fitting

• self-piercing "C" clamp saddle valve and related hardware

• 2 carbon filters

• spanner wrench

If you are missing any components, please call us immediately for assistance.

Step 2. – Install Stage 1 Carbon Filter

Unscrew the sump (the vessel that holds the actual filter cartridge) from the housing cap / mounting

bracket assembly. The Stage 1 carbon filter is installed in the sump on the left side when facing the

front of the unit. Remove the protective plastic film that protects the sediment pre-filter and install

it in the sump. Make sure that it slips down over the sump standpipe (the raised portion at the

bottom of the inside of the sump). This will ensure that the filter is properly centered in the

housing. Turn the sump onto the housing cap and hand tighten. Make sure that the filter slips over

the cap standpipe. Do not over-tighten!