Divio NDR255P Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Divio NDR255P. Divio NDR255P 20 pages. Full hd extreme wdr dome network camera

Imprimer la page

Camera Cabling

Please follow the instructions below to complete IP Camera connection.

2.1

Connect Power

For power connection, please refer to section

Indoor models, and see section

Outdoor models. Alternatively, users can power the camera by PoE. Refer to the

section below to connect the Ethernet cable for PoE connection.

2.2

Connect Ethernet Cable

Use of Category 5 Ethernet cable is recommended for network / PoE connection.

For best transmission quality, cable length shall not exceed 100 meters. Connect

one end of the Ethernet cable to the RJ-45 connector of the camera / function

cable, and plug the other end of the cable to the network switch or PC.

Check the status of the link indicator and activity indicator LEDs. If the LEDs are

unlit, please check the LAN connection.

2.3

Connect Alarm I/O

For Indoor models, there is an 8 pins terminal block for the Alarm I/O and the

Audio I/O connections. For Outdoor models, the Alarm I/O is connected by a

pins terminal block. Refer to sections

Cable Definition (Outdoor Only)

http://www.diviotec.com

NOTE: If PoE is used, make sure Power Sourcing Equipment (PSE) is in

used in the network.

NOTE: In some cases, Ethernet crossover cable might be needed when

connecting the camera directly to the PC.

Green Link Light indicates good network connection.

Orange Activity Light flashes for network activity indication.

Connectors (Indoor Only)

Function Cable Definition (Outdoor Only)

Connectors (Indoor Only)

for the pin definitions.

for the

and

Function